You receive a "The command line argument is not valid" error message when you use the /unregserver command-line switch and the /regserver command-line switch in Outlook 2003

Article translations Article translations
Article ID: 827593 - View products that this article applies to.
Expand all | Collapse all

SYMPTOMS

When you use the /unregserver command-line switch and the /regserver command-line switch, you may receive the following error message in Microsoft Office Outlook 2003:
Cannot start Microsoft Office Outlook. The command line argument is not valid. Verify the switch you are using.

CAUSE

This behavior occurs because both the /unregserver command-line switch and the /regserver command-line switch are no longer valid in Outlook 2003.

STATUS

This behavior is by design.

Properties

Article ID: 827593 - Last Review: September 28, 2004 - Revision: 1.3
APPLIES TO
  • Microsoft Office Outlook 2003
Keywords: 
kbcommandline kbpending kberrmsg kbprb KB827593

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com