X400: Typical Batch Files to Set Up and Start X.400 Gateway

Retired KB Content Disclaimer

View products that this article applies to.

This article was previously published under Q86972

Expand all | Collapse all

SUMMARY

The CONFIG.SYS files do not change when either the X.25 Eicon card or the redirector software is installed.

The AUTOEXEC.BAT files may contain the following startup:

   Server Startup
      nabios srv gateway /4
      ecload

Or, if the workstation is a redirector workstation:

   Eicon Redirector Software Startup
      nabios rdr gateway /4
      x25net start

A typical X.400 startup batch file appears as follows:

   x400gate -dq -lv

The Eicon X.25 card installation manual contains additional examples of installation and startup batch files.

APPLIES TO

Microsoft Mail Gateway to X.400 3.0

Back to the top

KB86972

Retired KB Content Disclaimer

This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.

Back to the top