Article ID: 907343 - View products that this article applies to.
When you start one of the products that are listed in the "Applies To" section, you receive an error message that resembles the following:
When you click OK in the error message, you receive the same error message again. Later, if you try to open a new project file or an existing project file, you receive the same error message two times. Additionally, the project opens but cannot be seen.
One or more ActiveX controls could not be displayed because either: 1) Your current security settings prohibit running ActiveX controls on this page, or 2) You have blocked a publisher of one of the controls. As a result, the page may not display correctly.
This issue occurs if the following conditions are true:
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
To resolve this issue, use one of the following methods.
(http://support.microsoft.com/kb/833633/ )How to strengthen the security settings for the Local Machine zone in Internet Explorer
Method 2Turn off the Project Guide. To do this, perform one of the following actions, depending on your version of Project:
Article ID: 907343 - Last Review: December 12, 2006 - Revision: 3.5
Contact us for more help