This article describes how to troubleshoot problems with your Xbox 360 Universal Media Remote.

Back to the top

When you use your Xbox 360 Universal Media Remote, you may experience one or more of the following problems:

•	The DVD features don't work.
•	The video quality is poor or doesn't work.
•	The sound quality is poor or doesn't work.
•	The buttons don't work.
•	You experience poor performance when you use your remote control with your Xbox 360 console.
•	The TV code doesn't work.

If you experience any one of these problems, see the corresponding section in this article.

Back to the top

The DVD features don't work

Some DVDs may not support all the Xbox 360 DVD playback features. Some features that are typically affected include the following:

•	Subtitles
•	Multilingual audio tracks
•	Multiple viewing angles
•	Slow-motion play

For more information about the features that are supported, see the production documentation for the affected DVD. In rare instances, certain DVDs may not operate correctly. Typically, this behavior occurs because of variations in the manufacturing process or software encoding of the DVD video software.

Back to the top

The video quality or the sound quality is poor or doesn't work

Make sure that the AV cable is attached correctly. For information about Setup and AV troubleshooting steps, see your Xbox 360 Setup manual or the instructions for the AV cable.

Back to the top

The buttons don't work

•	Check for interference. Remove any objects that may block the infrared port on the remote or on the console. This includes metallic or metallic-painted faceplates on the console.
•	If the infrared port on the faceplate is damaged, replace the faceplate.
•	Put new batteries in the remote control to determine whether the behavior is caused by weak batteries. Remove the batteries from the remote control, press each button two times, and then replace the batteries.

Back to the top

You experience poor performance when you use the remote control with your Xbox 360 console

•	Make sure that the remote control has new batteries.
•	Point the remote directly at the infrared sensor next to memory unit slot A.
•	Verify that the infrared sensor is not blocked or covered.
•	Make sure that you use the remote control no more than 10 feet from the infrared sensor on the console.
•	Close drapes and blinds during daylight hours to minimize any ambient infrared light.

Back to the top

The TV code doesn't work

To scan for the correct TV code, follow these steps:

1.	Turn on the TV, and then point the remote control toward the TV.
2.	Press and hold the TV button and the OK button at the same time for two seconds. All the buttons on the remote control will illuminate for two seconds. Then, only the numeric TV buttons (1 through 12) remain illuminated.
3.	Press the CH+ button or the CH– button to send a series of off commands to the TV. Continue to press the CH+ button or the CH– button until the TV turns off. Note Give enough time for the TV to respond to the off command after you press each button. Some TVs take more time to react to the off command than other TVs.
4.	Press the TV button to save the code and to exit. All the buttons on the remote control will blink three times to confirm the code.

If you want help troubleshooting a problem with your Xbox 360 Universal Media Remote, contact Xbox Customer Support. For more information about how to contact Xbox Customer Support, visit the Xbox Support (http://www.xbox.com/support/) Web site.

Important Don't take your Xbox 360 console or its accessories to your retailer for repair or service unless an Xbox Customer Support representative instructs you to do this.

Back to the top

Additional support

Please visit the following Web site for information about how to contact Xbox Customer Support:

Back to the top