Article ID: 917385 - View products that this article applies to.
When you try to run the Active Directory Installation Wizard on a Microsoft Windows Server 2003 R2 server, the wizard does not finish, and you may receive the following error message:
The Active Directory Installation Wizard cannot continue because the forest is not prepared for installing Windows Server 2003. Use the Adprep command-line tool to prepare both the forest and the domain. For more information about using the Adprep, see Active Directory Help.
The version of the Active Directory schema of the source forest is not compatible with the version of Active Directory on this computer.
This issue may occur when Active Directory has not been updated with the Windows Server 2003 R2 schema extensions..
To resolve this issue, run the adprep.exe /forestprep command from the Windows Server 2003 R2 installation disk 2 on the schema master. To do this, insert the Windows Server 2003 R2 installation disk 2, and then type the following command:
The correct version of the ADPrep.exe tool for Windows Server 2003 R2 is 5.2.3790.2075.
You can verify the operating system support level of the schema by looking at the value of the
Schema Versionregistry subkey on a domain controller. You can find this subkey in the following location:
You can also verify the operating system support level of the schema by using the Adsiedit.exe utility or the Ldp.exe utility to view the objectVersion attribute in the properties of the cn=schema,cn=configuration,dc=<domain> partition. The value of the
Schema Versionregistry subkey and the objectVersion attribute are in decimal.
Schema Version ObjectVersion values and corresponding operating system support level
Windows Server 2003 R2 installation disksWindows Server 2003 R2 comes on two installation disks. Installation disk 1 contains a slip-streamed version of Windows Server 2003 with Service Pack 1 (SP1). Installation disk 2 contains the Windows Server 2003 R2 files. If the computer has Windows Server 2003 SP1 installed, you may only have to run installation disk 2 to upgrade to Windows Server 2003 R2.
Installation disk 2 is specific to the edition of Windows Server 2003. For example, you must use a Windows Server 2003 R2, Standard Edition installation disk to upgrade a Windows Server 2003, Standard Edition-based computer. Installation disk 2 contains installation files for the x86-based version and the x64-based version of Windows Server 2003 R2.
The Adsiedit.exe utility and the Ldp.exe utility are included with Windows Server 2003 R2 support tools. To install support tools, run Suptools.msi from the \Support\Tools folder on installation disk 1.
Article ID: 917385 - Last Review: July 24, 2007 - Revision: 5.2