Article ID: 927152 - Last Review: October 15, 2007 - Revision: 1.1

The status bar displays a flashing message or displays alternate messages when you apply a filter to a subreport in Access 2007: "Calculating," "Ready," or another status

View products that this article applies to.
System TipThis article applies to a different operating system than the one you are using. Article content that may not be relevant to you is disabled.

On This Page

Expand all | Collapse all

SYMPTOMS

When you apply a filter to a subreport in Microsoft Office Access 2007, you may experience the following symptoms:
  • The status bar in Access 2007 displays the following flashing message:
    Calculate
  • The status bar indicates that the status of Access 2007 continually changes. For example, the status bar alternately displays messages such as the following:

    Message 1
    Ready
    Message 2
    Calculating
  • Data that is contained in the report alternates between being visible and not being visible.
  • Data that is contained in the report alternates between #Name and the actual cell value.
Back to the top

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
Back to the top

MORE INFORMATION

Steps to reproduce the problem

  1. Open a database in Access 2007.
  2. Open a subreport in layout mode.
  3. Click a cell, and then apply a filter.
Back to the top
APPLIES TO
  • Microsoft Office Access 2007
Back to the top
Keywords: 
kbtshoot kbbug kbprb kbexpertiseinter KB927152
Back to the top