Article ID: 927695 - View products that this article applies to.
Transmission Control Protocol (TCP) connections are reset when Receive Side Scaling is enabled in Microsoft Windows Server 2003 with Service Pack 2 (SP2). This problem occurs if you use Network Address Translation (NAT), if you use Windows Firewall, or if the host computer is configured to be an Internet Connection Sharing host server computer.
Note This problem may also occur when you use the following products:
This problem is caused when the software hash code for the connection and the hardware hash code for the connection do not match. Receive Side Scaling works by offloading the TCP secure hash function to the network adapter hardware. Therefore, the network adapter calculates the hash value for the connection when Receive Side Scaling is enabled. Internet Connection Sharing also modifies the addresses and the ports that are provided by the IP header for the connection. When this occurs, the hash value that is generated by the network adapter is invalidated. When the invalidated hash value is used, the TCP connection is reset.
This problem may also occur if the IP source address, the IP destination address, the TCP source port, or the TCP destination port are modified during receive processing. These addresses and ports are provided in the TCP and IP headers for the connection. This problem may occur in some NAT scenarios.
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
To work around this problem, disable Receive Side Scaling when the computer is configured as an Internet Connection Sharing gateway. To do this, follow these steps:
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
For more information, click the following article number to view the article in the Microsoft Knowledge Base:
936594For more information, visit the following Microsoft Web site:
(http://support.microsoft.com/kb/936594/ )You may experience network-related problems after you install Windows Server 2003 S or the Scalable Networking Pack on a Windows Server 2003-based computer
Article ID: 927695 - Last Review: December 4, 2007 - Revision: 4.7
Contact us for more help
Connect with Answer Desk for expert help.