After you apply Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1, you can configure the notifications for scan engine errors and for scan engine time-outs

Article translations Article translations
Article ID: 952816 - View products that this article applies to.
Expand all | Collapse all

On This Page

INTRODUCTION

Consider the following scenario:
  • You are running either the release version of Microsoft Antigen 9.0 for Exchange or Antigen 9.0 for Exchange with Service Pack 1 (SP1).
  • You enable notifications for the senders and recipients of e-mail messages.
If a scan engine error or a scan engine time-out occurs in this scenario, the sender and recipients of the affected e-mail message are notified. However, after you apply Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1, you now have the following options:
  • To disable only the scan engine error notifications or only the scan engine time-out notifications
  • To configure Antigen to send the error and time-out notifications only to the virus administrator instead of to all senders and recipients of the affected e-mail message

    Note You can configure this option in the Virus Administrator Notification console.
  • To enable error and time-out notifications to all senders and recipients
After you apply Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1, the following registry subkeys are created:
  • EngineTimeOutNotification
    This controls time-out notifications.
  • EngineErrorNotification
    This controls engine error notifications.
You can set these subkeys to one of the following values:
  • 0
    The new functionality from Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1 is disabled. (Therefore, the functionality of Antigen 9.0 is unchanged.)
  • 1
    Antigen 9.0 for Exchange sends notifications only to virus administrators.
  • Any other value
    All notifications are disabled.

MORE INFORMATION

How to obtain the hotfix rollup

For more information about how to obtain and install Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1, click the following article number to view the article in the Microsoft Knowledge Base:
950791 Description of Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1
Note Before you install Hotfix Rollup 3 for Antigen 9.0 for Exchange with Service Pack 1, you must have Antigen 9.0 Service Pack 1 installed.

Properties

Article ID: 952816 - Last Review: June 13, 2008 - Revision: 1.1
APPLIES TO
  • Microsoft Antigen for Exchange
  • Microsoft Antigen for Exchange Service Pack 1
Keywords: 
kbhowto kbexpertiseinter KB952816

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com