Article ID: 954655 - Last Review: February 12, 2009 - Revision: 3.0 Microsoft Dynamics CRM 4.0 does not perform a uniqueness check on a product number after you add a custom attribute to a Product entity
SYMPTOMSAfter you add a custom attribute to a Product entity,
Microsoft Dynamics CRM 4.0 does not perform a uniqueness check on the
product number. Therefore, if you add a product that
has an identifier (ID) that already exists to Microsoft Dynamics CRM, you do
not receive the following error message as expected: The
product ID conflicts with an existing product ID. Try your request again with a
new ID. RESOLUTIONThis problem is fixed in the latest cumulative update rollup for Microsoft Dynamics CRM 4.0. For more information, click the following article number to view the article in the Microsoft Knowledge Base:
949256
(http://support.microsoft.com/kb/949256/
)
Microsoft Dynamics CRM 4.0 updates and hotfixes
STATUSMicrosoft
has confirmed that this is a problem in the Microsoft products that are listed
in the "Applies to" section. MORE INFORMATIONFor more information about the terminology that is used to describe Microsoft software updates, click the following article numbers to view the articles in the Microsoft Knowledge Base: 824684
(http://support.microsoft.com/kb/824684/
)
Description of the standard terminology that is used to describe Microsoft software updates 887283
(http://support.microsoft.com/kb/887283/
)
Microsoft Business Solutions CRM software hotfix and update package naming standards
| Article Translations
|
| United States | Change | | | All Microsoft Sites |
Back to the top
|
