Article ID: 955784 - View products that this article applies to.
After you use Windows Cluster Administrator tool to change the network name of a Microsoft SQL Server 2008 Analysis Services failover cluster instance, you cannot use the SQL Server Setup program to modify the SQL Server 2008 Analysis Services failover cluster instance that has the changed network name.
This problem occurs because the name for the cluster instance is not changed in the registry when you perform the change in a tool that is not a part of SQL Server.
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
322756To resolve this problem, change the cluster name in the registry on each node in the failover cluster. To modify the cluster name on a node in the cluster, follow these steps.
(http://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
Note The node can remain online because the registry entry is only used by the Setup program.
Article ID: 955784 - Last Review: September 19, 2008 - Revision: 1.0