Select the product you need help with

iSCSI target does not reconnect after loading network drivers during setup

Article ID: 960924 - View products that this article applies to.

Source: Microsoft Support

RAPID PUBLISHING

RAPID PUBLISHING ARTICLES PROVIDE INFORMATION DIRECTLY FROM WITHIN THE MICROSOFT SUPPORT ORGANIZATION. THE INFORMATION CONTAINED HEREIN IS CREATED IN RESPONSE TO EMERGING OR UNIQUE TOPICS, OR IS INTENDED SUPPLEMENT OTHER KNOWLEDGE BASE INFORMATION.

Back to the top | Give Feedback

Symptom

If you install Windows 2008 from a WDS server or over the network using PXE, the WINPE installation wizard does not update with an iscsi target disk list when you manually load a network driver after WINPE has booted. The user can ping the iscsi boot target device after the driver loads, but the UI does not update. This is the case both with the "load driver" option in the UI and with drvload.exe. This is also the case when you upgrade inbox drivers with a newer version. The inbox drivers connect and show the target LUNs in the UI, but after loading the new driver, the UI no longer shows the target though network access is still present.

Back to the top | Give Feedback

Cause

Back to the top | Give Feedback

Resolution

To work around this issue, use one of the following methods:

1. If the NIC / iSCSI HBA has in-box drivers, complete Setup using those drivers then update them following the installation.

2. Inject the updated drivers into the WIM images used to deploy Server 2008.

Back to the top | Give Feedback

DISCLAIMER

MICROSOFT AND/OR ITS SUPPLIERS MAKE NO REPRESENTATIONS OR WARRANTIES ABOUT THE SUITABILITY, RELIABILITY OR ACCURACY OF THE INFORMATION CONTAINED IN THE DOCUMENTS AND RELATED GRAPHICS PUBLISHED ON THIS WEBSITE (THE “MATERIALS”) FOR ANY PURPOSE. THE MATERIALS MAY INCLUDE TECHNICAL INACCURACIES OR TYPOGRAPHICAL ERRORS AND MAY BE REVISED AT ANY TIME WITHOUT NOTICE.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, MICROSOFT AND/OR ITS SUPPLIERS DISCLAIM AND EXCLUDE ALL REPRESENTATIONS, WARRANTIES, AND CONDITIONS WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT LIMITED TO REPRESENTATIONS, WARRANTIES, OR CONDITIONS OF TITLE, NON INFRINGEMENT, SATISFACTORY CONDITION OR QUALITY, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE MATERIALS.

Back to the top | Give Feedback