Article ID: 967754 - View products that this article applies to.
RAPID PUBLISHING ARTICLES PROVIDE INFORMATION DIRECTLY FROM WITHIN THE MICROSOFT SUPPORT ORGANIZATION. THE INFORMATION CONTAINED HEREIN IS CREATED IN RESPONSE TO EMERGING OR UNIQUE TOPICS, OR IS INTENDED SUPPLEMENT OTHER KNOWLEDGE BASE INFORMATION.
Installation of x64 Windows from cross-platform media (x86 WinPE) to an iSCSI boot disk fails late in install with error, "Windows installation cannot continue because a required driver could not be installed."
The iSCSI boot specific Setup code is not cross-platform aware.
When using a NIC-based iSCSI boot solution and cross-platform media, installation will fail in the WinPE phase of Setup.
When using an HBA-based iSCSI boot solution and cross-platform media, failure of the installation may occur after Setup has completed.
You must use the same architecture for WinPE as the target deployment architecture when deploying to an iSCSI boot disk.
For example, if you are installing x64 architecture Windows, you must use x64 architecture WinPE (such as x64 architecture-only installation media).
Cross-platform media, such as cross-platform media available on MSDN, or cross-platform media created using the OEM Preinstallation Kit (OPK), will fail in this iSCSI boot scenario.
MICROSOFT AND/OR ITS SUPPLIERS MAKE NO REPRESENTATIONS OR WARRANTIES ABOUT THE SUITABILITY, RELIABILITY OR ACCURACY OF THE INFORMATION CONTAINED IN THE DOCUMENTS AND RELATED GRAPHICS PUBLISHED ON THIS WEBSITE (THE “MATERIALS”) FOR ANY PURPOSE. THE MATERIALS MAY INCLUDE TECHNICAL INACCURACIES OR TYPOGRAPHICAL ERRORS AND MAY BE REVISED AT ANY TIME WITHOUT NOTICE.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, MICROSOFT AND/OR ITS SUPPLIERS DISCLAIM AND EXCLUDE ALL REPRESENTATIONS, WARRANTIES, AND CONDITIONS WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT LIMITED TO REPRESENTATIONS, WARRANTIES, OR CONDITIONS OF TITLE, NON INFRINGEMENT, SATISFACTORY CONDITION OR QUALITY, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE MATERIALS.
Article ID: 967754 - Last Review: February 10, 2009 - Revision: 1.0
Contact us for more help