Article ID: 968847 - View products that this article applies to.
RAPID PUBLISHING ARTICLES PROVIDE INFORMATION DIRECTLY FROM WITHIN THE MICROSOFT SUPPORT ORGANIZATION. THE INFORMATION CONTAINED HEREIN IS CREATED IN RESPONSE TO EMERGING OR UNIQUE TOPICS, OR IS INTENDED SUPPLEMENT OTHER KNOWLEDGE BASE INFORMATION.
Addresses that should be shown in the Do not use proxy server for addresses beginning with section under the Internet Options Advanced Proxy Settings page are not shown. The registry entries still exist and Internet Explorer will still bypass the Web sites.
This is caused by the configuration of different proxy servers by protocol, where one is the Gopher proxy server.
Note Internet Explorer 7 does not support the Gopher protocol. For this problem to occur, the Gopher protocol would have to have been set in older Group Policies or from an earlier version of Internet Explorer before Internet Explorer 7 was installed.
If the configuration was set through Group Policy
· Remove the value for the Gopher proxy server specified in the Group Policy.
If the configuration was not set through Group Policy
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/322756)How to back up and restore the registry in Windows
To modify the registry entry, follow these steps:
1. Click Start, click Run, and in the Open box, type the following:
2. Locate the ProxyServer value under the following key in the registry:
3. On the Edit menu, click Edit, String.
4. Remove the entry associated with Gopher (for example, remove gopher=proxyserver:80;), and then click OK .
5. Exit Registry Editor.
MICROSOFT AND/OR ITS SUPPLIERS MAKE NO REPRESENTATIONS OR WARRANTIES ABOUT THE SUITABILITY, RELIABILITY OR ACCURACY OF THE INFORMATION CONTAINED IN THE DOCUMENTS AND RELATED GRAPHICS PUBLISHED ON THIS WEBSITE (THE “MATERIALS”) FOR ANY PURPOSE. THE MATERIALS MAY INCLUDE TECHNICAL INACCURACIES OR TYPOGRAPHICAL ERRORS AND MAY BE REVISED AT ANY TIME WITHOUT NOTICE.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, MICROSOFT AND/OR ITS SUPPLIERS DISCLAIM AND EXCLUDE ALL REPRESENTATIONS, WARRANTIES, AND CONDITIONS WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT LIMITED TO REPRESENTATIONS, WARRANTIES, OR CONDITIONS OF TITLE, NON INFRINGEMENT, SATISFACTORY CONDITION OR QUALITY, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE MATERIALS.
Contact us for more help
Connect with Answer Desk for expert help.