Article ID: 183607 - View products that this article applies to.
This article was previously published under Q183607
This article explains how to use the DCOM configuration utility DCOMCNFG.EXE to configure DCOM for remote client/server applications created using Microsoft Visual Basic 5.0.
Incorrectly setting up security for DCOM client/server applications will typically result in the following errors:
Run-time error '429'
ActiveX component can't create object.
Run-time error '70'
This article does not discuss the settings required to enable client access through firewalls. Please contact Microsoft Technical Support to obtain assistance regarding firewalls, proxy servers, or domain controllers.
The following settings will enable Windows NT or Windows 2000 to communicate with an NT or Windows client and back (assuming that there are no firewalls or proxy servers involved).
To configure your Visual Basic DCOM "Server" on an NT or Windows 2000machine, follow these steps: (Note that DCOMCNFG will only show servers that are EXEs. It will not show DLL servers.)
On the NT or Windows 2000 SERVER machine:
If your application works at this point, then you should not need to make any configuration settings on the client machines.
If your client is receiving events raised from the server or has enabled the server to call it back, then the following steps might be necessary, depending upon your specific network:
To configure your Visual Basic DCOM "Clients:"
On the NT or Windows CLIENT machines:
NOTE: DCOM registry keys are intended for Legacy software and not for Proprietary software or programming convenience.
For more detailed information regarding DCOM security settings, please see the following articles in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/176799/EN-US/ ): INFO: Using DCOM Config (DCOMCNFG.EXE) on Windows NT
(http://support.microsoft.com/kb/182248/EN-US/ ): How To : Use DCOM Config (DCOMCNFG.EXE) on Windows 95
For more information regarding using WIN95 as a DCOM server, please see the following article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/165101/EN-US/ ): How To Use Windows as a DCOM Server
Visual Basic 5.0 can use remote events callbacks to enable two-way communication between DCOM clients and a DCOM server application.
For more information regarding using remote events or callbacks with DCOM and Visual Basic 5.0, please see the following article in the Microsoft Knowledge Base:
175510(c) Microsoft Corporation 1998, All Rights Reserved.
(http://support.microsoft.com/kb/175510/EN-US/ ): FILE: VB5DCOM.EXE: Using Callbacks and WithEvents with DCOM
Contributions by Randy Russell, Microsoft Corporation
Article ID: 183607 - Last Review: June 29, 2004 - Revision: 2.1
Contact us for more help
Connect with Answer Desk for expert help.