Command "pmadmin set dbserver" Resets Unspecified Parameters

Retired KB Content Disclaimer

View products that this article applies to.

This article was previously published under Q187954

Expand all | Collapse all

SYMPTOMS

When issuing the command "pmadmin set dbserver", you may find that the parameters that you did not specify in the command line will be reset.

Back to the top

CAUSE

Pmadmin uses the parameters that are passed in the command line to set the configuration. If a parameter is not specified, pmadmin resets the configuration to hard-coded defaults.

Back to the top

RESOLUTION

To resolve this problem, apply the latest Site Server 3.0 service pack.

Back to the top

Microsoft has confirmed this to be a problem in Site Server version 3.0. This problem was corrected in the latest Microsoft Site Server version 3.0 U.S. Service Pack. For information on obtaining the service pack, query on the following word in the Microsoft Knowledge Base (without the spaces):

S E R V P A C K

Back to the top

APPLIES TO

Microsoft Site Server 3.0 Standard Edition

Back to the top

kbbug kbfix kbsiteserv300sp1fix KB187954

Back to the top

Retired KB Content Disclaimer

This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.

Back to the top