Help and Support

Older Disk Controllers Incompatible with Protected-Mode Driver

View products that this article applies to.
Article ID:134298
Last Review:November 15, 2006
Revision:1.1
This article was previously published under Q134298

SYMPTOMS

After you install Windows 95 on a Compaq DeskPro 16 computer (circa 1988), you may receive the following error message:
Your system is not configured for its fastest performance
If you click the Details button, you receive the following message: 
   Drive C: using MS-DOS Compatibility mode

Back to the top

CAUSE

Certain older computers with proprietary disk controllers exhibit this behavior. Windows 95 protected-mode disk drivers are not guaranteed to work with IDE controllers using proprietary firmware to access drives.

The proprietary firmware in some older IDE disk controllers is not designed to work correctly with the Windows 95 INT 13 interface.

Back to the top

RESOLUTION

You must disable protected-mode support for older IDE controllers that exhibit this problem. To do so, disable the IDE/ESDI controller in Device Manager.

Back to the top

STATUS

This situation is most likely caused by design changes in Windows 95. Microsoft has confirmed that it is not caused by a problem in Windows 95.

Back to the top

APPLIES TO
•Microsoft Windows 95

Back to the top

Keywords: 
KB134298

Back to the top

Article Translations

 

Other Support Options

  • Need More Help?
    Contact a Support professional by Email, Online or Phone.
  • Customer Service
    For non-technical assistance with product purchases, subscriptions, online services, events, training courses, corporate sales, piracy issues, and more.
  • Newsgroups
    Pose a question to other users. Discussion groups and Forums about specific Microsoft products, technologies, and services.