Help and Support

Able to Print Only Once from Digitalk Parts Workbench 2.0

View products that this article applies to.
Article ID:135347
Last Review:November 15, 2006
Revision:1.1
This article was previously published under Q135347

SYMPTOMS

When you are running Digitalk Parts Workbench version 2.0 in Windows 95, you can print only once. If you try to print a second time, you receive the following error message:
Operating System Error

Back to the top

CAUSE

Digitalk Parts Workbench 2.0 is not completely compatible with Windows 95.

Back to the top

RESOLUTION

To print from Digitalk Parts Workbench 2.0 again, quit and then restart the program. For information regarding other solutions to this problem, please contact the software manufacturer.

Back to the top

STATUS

This situation is most likely caused by design changes in Windows 95. Microsoft has confirmed that it is not caused by a problem in Windows 95.

Back to the top

MORE INFORMATION

The third-party product discussed in this article is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

Back to the top

APPLIES TO
•Microsoft Windows 95

Back to the top

Keywords: 
KB135347

Back to the top

Article Translations

 

Other Support Options

  • Contact Microsoft
    Phone Numbers, Support Options and Pricing, Online Help, and more.
  • Customer Service
    For non-technical assistance with product purchases, subscriptions, online services, events, training courses, corporate sales, piracy issues, and more.
  • Newsgroups
    Pose a question to other users. Discussion groups and Forums about specific Microsoft products, technologies, and services.