Help and Support
 

powered byLive Search

Cannot Use Both Dial-Up Networking and Direct Cable Connection

View products that this article applies to.
Article ID:140208
Last Review:November 15, 2006
Revision:1.1
This article was previously published under Q140208

SYMPTOMS

You may experience either of the following symptoms:
•When you try to connect to a server or provider using Dial-Up Networking, you may receive the following error message:
Another Dial-Up Networking connection is active.
Disconnect the other connection, and then try again.
•When you try to establish a connection using Direct Cable Connection, you may receive the following error message:
Cannot connect to host computer. Make sure you have run Direct Cable Connection on the host computer and you have connected your cable to both computers.

Back to the top

CAUSE

Both Dial-Up Networking and Direct Cable Connection use the same network interface (Pppmac.vxd). You cannot have more than one instance of Pppmac.vxd running at one time.

Back to the top

RESOLUTION

Close Dial-Up Networking to run Direct Cable Connection, or close Direct Cable Connection to run Dial-Up Networking. You cannot run both at the same time.

Back to the top

APPLIES TO
•Microsoft Windows 95

Back to the top

Keywords: 
kbdialup KB140208

Back to the top

Article Translations

 

Other Support Options

  • Need More Help?
    Contact a Support professional by Email, Online or Phone.
  • Customer Service
    For non-technical assistance with product purchases, subscriptions, online services, events, training courses, corporate sales, piracy issues, and more.
  • Newsgroups
    Pose a question to other users. Discussion groups and Forums about specific Microsoft products, technologies, and services.