US Robotics Edgeserver Does Not Support Word for Windows 3.11 RAS Clients
This article was previously published under Q158991 SUMMARY
The US Robotics Edgeserver does not support Windows for Workgroups 3.11
Remote Access Service (RAS) clients. In order to connect to the US Robotics
Edgeserver, you must use a point-to-point protocol (PPP) compliant dial-up
client.
MORE INFORMATION
The US Robotics Edgeserver is a hardware Remote Access Service solution
that combines Windows NT Server 4.0 within the US Robotics Total Control
Enterprise Network Hub. Windows NT Server 4.0 is pre-installed on the
EdgeServer.
Although the Windows NT 4.0 Remote Access Service Server software supports Windows for Workgroups 3.11 RAS as a dial-up client, when used with the Edgeserver, only PPP compliant clients are supported. Contact US Robotics for more information on the US Robotics Edgeserver. For information about how to contact US Robotics, query in the Knowledge Base for one of the following articles:
ARTICLE-ID: 65416 (http://support.microsoft.com/kb/65416/EN-US/)
The product included here is manufactured by US Robotics, a vendor
independent of Microsoft; we make no warranty, implied or otherwise,
regarding this product's performance or reliability.
TITLE : Hardware and Software Third-Party Vendor Contact List, A-K ARTICLE-ID: 60781 (http://support.microsoft.com/kb/60781/EN-US/) TITLE : Hardware and Software Third-Party Vendor Contact List, L-P ARTICLE-ID: 60782 (http://support.microsoft.com/kb/60782/EN-US/) TITLE : Hardware and Software Third-Party Vendor Contact List, Q-Z APPLIES TO
| Article Translations
|
| United States | Change | | | All Microsoft Sites |
Help and Support
Back to the top
|
