Cluster service could not be started. Cluster service Configuration has completed successfully, but the cluster service failed on startup. Check the event log for the reason. Before attempting to run Cluster service Configuration again, you must uninstall the cluster software from the Add/Remove Programs applet in the control panel.
The Cluster Service terminated with the following error. The quorum disk could not be located by the cluster service.
Event ID 7031:
The Cluster Service service terminated unexpectedly. It has done this X time(s). The following corrective action will be taken in 60000 milliseconds: Restart the service.
Event ID 1009:
The Clustering Service could not join an existing cluster and could not form a new cluster. The Clustering Service has terminated.
To properly configure your Dell PERC RAID controllers, follow these steps for each logical drive in the array:
- During POST, press CTRL+M when you are prompted to enter the PERC BIOS Configuration Utility.
- In the Management menu, click Objects\Logical Drive/View\Update Parameters.
- Note If you have a PERC4 controller, you may skip this step and execute step 4.
Click Write policy, and then press ENTER. Configure the policy for Write-Thru. This option should now appear as:Write Policy = WRTHRU
- On the Management menu, click Objects\Adapter and then press ENTER. Click Cluster Mode, and then press ENTER. Change the option to Enabled. This option should now appear as:Cluster Mode = Enabled
Note If you enable Cluster Mode when you configure your Perc Controllers, you are automatically prompted to enable the
Write-Thru cache. When you enable the
Write-Thru cache, the PERC BIOS Configuration Utility resets the Initiator ID (SCSI ID) to the default of 7. The Initator ID must be unique on each node. Otherwise, disk reservation will be lost when you power up any node that is connected to the shared resources.
- Save the configuration, exit the utility, and then restart the computer.
[DM] DmInitialize: The hive was loaded- rollback, unload and reload again
[JOIN] Spawning thread to connect to sponsor 184.108.40.206
[JOIN] Asking 220.127.116.11 to sponsor us.
[JOIN] JoinVersion data for sponsor 18.104.22.168 is invalid, status 1722.
[JOIN] Unable to connect to any sponsor node.
[INIT] Failed to join cluster, status 53
[FM] arbitrate for quorum resource id 3b1a7008-a269-4c93-a89d-f5b21a0722ca.
[FM] FmGetQuorumResource failed, error 170.
[INIT] ClusterForm: Could not get quorum resource. No fixup attempted. Status = 5086
[INIT] Failed to form cluster, status 5086.
[CS] ClusterInitialize failed 5086
[INIT] The cluster service is shutting down.
[FM] Shutdown: Failover Manager requested to shutdown groups.
[MM] MMLeave is called when rgp=NULL.
Artikelnummer: 296594 – Letzte Überarbeitung: 11.02.2010 – Revision: 1