Finishing operations after applying configuration
A parameter cannot be found that matches parameter name 'IPv4Address'.
Attempting to roll back the configuration.
This issue occurs when you try to remove two or more VPN IP address ranges in the same operation.
- Remove only a single VPN address range, and then apply the changes in the Remote Access console. Repeat this procedure until all the desired address ranges are removed.
- Use Windows PowerShell to remove individual address ranges one at a time by using the following cmdlet syntax:
Remove-VpnIPAddressRange -IPAddress <string> -ComputerName <string>For example, run the following cmdlet:
Remove-VpnIPAddressRange -IPAddress 192.168.1.1 -ComputerName DA.Contoso.com
Article ID: 2959632 - Last Review: 28 Apr 2014 - Revision: 1