The following Visual Basic sample code shows how to use mciSendCommand to specify the device used for WaveAudio output.
Sample CodeFollowing are the required definitions and declarations. Place these in a module file:
Public Const MMSYSERR_NOERROR = 0
Public Const MCI_SET = &H80D
Public Const MCI_WAVE_OUTPUT = &H800000
dwCallback As Long
dwTimeFormat As Long
dwAudio As Long
wInput As Long
wOutput As Long
wFormatTag As Integer
wReserved2 As Integer
nChannels As Integer
wReserved3 As Integer
nSamplesPerSec As Long
nAvgBytesPerSec As Long
nBlockAlign As Integer
wReserved4 As Integer
wBitsPerSample As Integer
wReserved5 As Integer
Declare Function mciGetErrorString Lib "winmm.dll" _
Alias "mciGetErrorStringA" (ByVal dwError As Long, _
ByVal lpstrBuffer As String, ByVal uLength As Long) As Long
Declare Function mciSendCommand Lib "winmm.dll" Alias _
"mciSendCommandA" (ByVal wDeviceID As Long, _
ByVal uMessage As Long, ByVal dwParam1 As Long, _
ByRef dwParam2 As Any) As Long
Sample CodeThe following code sets the output device. This code assumes that you have a Multimedia Control called "MMControl1." This code should be called after the wave file to be played has been opened by MMControl1.
Dim parms As MCI_WAVE_SET_PARMS
Dim rc As Long
' Specify the soundcard. This specifies the soundcard with a deviceID
' of 0. If you have a single soundcard, then this will open it. If you
' have multiple soundcards, the deviceIDs will be 0, 1, 2, etc.
parms.wOutput = 0
' Send the MCI command to set the output device.
rc = mciSendCommand(MMControl1.DeviceID, MCI_SET, _
if (rc <> MMSYSERR_NOERROR) then
' The command failed.
Article ID: 180032 - Last Review: Nov 21, 2006 - Revision: 1