The document is not saved.
If this process is interrupted, your file may not be saved properly or you may find one or more temporary files in the folder where you tried to save your file. In addition, you may receive one of several alert or error messages.
The following information lists some of the possible messages you may receive and explanations as to why you may receive them.
"Cannot access read-only document <file name>"The drive you are saving to is a network drive and you do not have sufficient privileges to save to that drive. Save to your local hard disk drive or to a floppy disk drive.
"Disk is full"The drive you are saving to does not have enough space for the temporary file. Delete some files from the current drive and save to another drive or to a floppy disk drive.
"Document not saved," or "Document not completely saved"The process was interrupted while creating the temporary file because you pressed ESC, there was some hardware or software failure, or there was another media problem. The original file is still intact and ,unless your computer or workstation failed, the version of the file containing your current changes is still open in memory. Save the file to an alternate drive. If your computer or workstation did fail, you can use the original file. (Note that any changes made in the last revision will be lost.)
"Document not saved. Any previously saved copy has been deleted"The process was interrupted while deleting the original or renaming the temporary file. This problem will occur for the same reasons as the scenario described in the "'Document not saved,' or 'Document not completely saved'" section. In this case, your original file is gone (though the temporary file may be readable). If your computer or workstation failed, use the temporary file. If the interruption was caused by something else, the version of the file containing your current changes is still open in memory. Save the file to an alternate drive.
Article ID: 214073 - Last Review: May 16, 2017 - Revision: 2