Issue 1Consider the following scenario:
- You configure two or more build agents to allow for concurrent build requests in a build controller.
- You select gated check-in as the trigger type when you define a build definition.
- The build definition has two or more build requests in the Queued state while another build request has the InProgress state.
In this scenario, some builds in the build definition might incorrectly run concurrently in the build definition after the build in the InProgress state finishes.
Issue 2When you try to run build requests in the build controller, the following exceptions are encountered, and the job fails:
Cause of Issue 1This issue occurs because of an error in the logic that decides which build is the next build.
When the InProgress build is finished, the incorrect logic might start more than one gated submission on a definition.
Cause of Issue 2This issue occurs because errors exist in the build warehouse adapter and in the test management adapter.
Hotfix informationA supported hotfix is now available from Microsoft. However, it is intended to correct only the problem that this article describes. Apply it only to systems that are experiencing this specific problem.
To resolve this problem, contact Microsoft Customer Support Services to obtain the hotfix. For a complete list of Microsoft Customer Support Services telephone numbers and information about support costs, visit the following Microsoft website:Note In special cases, charges that are ordinarily incurred for support calls may be canceled if a Microsoft Support Professional determines that a specific update will resolve your problem. The usual support costs will apply to additional support questions and issues that do not qualify for the specific update in question.
PrerequisitesTo apply this hotfix, you must have Microsoft Visual Studio 2010 Service Pack 1 (SP1) installed.
Restart requirementYou have to restart the computer after you apply this hotfix if the affected files are being used.
Hotfix replacement informationThis hotfix does not replace a previously released hotfix.
File information The global version of this has the file attributes (or later file attributes) that are listed in the following table. The dates and times for these files are listed in Coordinated Universal Time (UTC). When you view the file information, it is converted to local time. To find the difference between UTC and local time, use the Time Zone tab in the Date and Time item in Control Panel.
|File name||File version||File size||Date||Time||Platform|
Article ID: 2567437 - Last Review: Oct 24, 2011 - Revision: 1