Consider the following scenario:
- You configure the PNPUnloadDelay setting in the following registry subkey on a Windows Embedded CE 6.0 R3-based device.
- You insert a storage device into the device.
- You remove the storage device, and then you insert it again within the time frame that is defined by the PNPUnloadDelay setting.
Note This issue typically occurs after you install hotfix 2643056 .
Software update informationA supported software update is now available from Microsoft as Windows Embedded CE 6.0 Monthly Update October 2013. In the "File information" section, the package file name contains the product version, the date, the Microsoft Knowledge Base article number, and the processor type. The package file name format is as follows:
Product version-yymmdd-kbnnnnnn-processor type
For example, Wincepb60-110128-kb2492159-armv4i.msi is the ARMV4i Windows Embedded CE 6.0 Platform Builder fix that is documented in Knowledge Base article 2492159 and that is contained in the January 2011 monthly update.
Note This Windows Embedded CE 6.0 monthly update is available for download from the following Microsoft Download Center website:
PrerequisitesThis update is supported only if all previously issued updates for this product have also been installed.
Restart requirementAfter you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:
- On the Build menu, click Clean Solution, and then click Build Solution.
- On the Build menu, click Rebuild Solution.
Update replacement informationThis update does not replace any other updates.
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
For more information about software update terminology, click the following article number to view the article in the Microsoft Knowledge Base:
824684 Description of the standard terminology that is used to describe Microsoft software updates