Windows Setup in a boot from SAN configuration reports "Setup was unable to create a new system partition or locate an existing system partition."

Applies to: Windows Server 2008 StandardWindows Server 2008 EnterpriseWindows Server 2008 Datacenter


Consider the following scenario:
  • You are installing Windows Server 2008, Windows Server 2008 R2, or Window Server 2012 in a boot from SAN configuration
  • There are multiple physical paths to the boot LUN
  • The boot LUN is raw and has not been initialized by Windows

In this scenario, when you select the boot LUN in on the "Where do you want to install Windows?" step of the installation wizard, all paths to the LUN are displayed separately and a message is displayed:

Windows Server 2012 and Windows Server 2008 R2:
"Setup was unable to create a new system partition or locate an existing system partition. See the Setup log files for more information."

Select Disk

Windows Server 2008:
"Windows cannot find a system volume that meets requirements for installation."


Windows is unable to install to a RAW disk with multiple physical paths. If the boot LUN is presented on a single physical path or if the boot LUN has already been initialized prior to installing Windows, Setup will proceed as expected.


There are two methods for working around this behavior.

Method 1: Present the boot LUN on a single path

Configure a single path to the boot LUN when installing Windows. For multiple HBA port configurations, only one HBA port should be connected to the SAN during Windows Setup. 

Method 2: Initialize the boot LUN prior to running setup

This method is ideal for scenarios where physically disconnecting the additional SAN connections is not possible or is difficult.

In multiple-path disk configurations Windows Setup does not recognize a disk as bootable until the disk is initialized and the disk signature is present.  To initialize the boot LUN and prepare the disk for Windows Setup, you must create a new partition and then delete the newly created partition. Creating a new partition will initialize the disk, write the disk signature, and create a partition. Deleting the partition will remove the newly created partition but leave the disk initialized with the disk signature. It is important to delete the partition so Windows Setup can create both the System Reserved partition and the Operating System Volume. Otherwise, Windows Setup does not create the System Reserved partition.

Detailed steps for Method 2 are as follows:
  1. In the Install Windows dialog box of Windows Setup, under "Where do you want to install Windows?", select Disk 0 and then click the Drive Options (advanced) link.
  2. Select New to create a new partition. 
  3. Click Apply to accept the default partition size.
  4. Click OK on the dialog box that explains that additional partitions may be created automatically by Windows.
  5. Now, select Delete to remove the newly created partition while leaving the disk in its initialized state.
  6. Click OK on the warning dialog box to acknowledge that any data on the disk will be lost.
  7. Reboot the system and run Windows Setup normally. Windows Setup will recognize the disk and Setup will continue.