FIX: Incorrect behavior of the scroll box on a ListBox control on a Windows Embedded Compact 7-based device

Symptoms

Assume that you run a Microsoft Silverlight for Windows Embedded application on a Windows Embedded Compact 7-based device. The application has a UserControl control that contains a ListBox control. You set the ItemsSource property of the ListBox control so that enough items are available to trigger the vertical scroll bar to be displayed. In this situation, you may experience any of the following issues:
  • The size of the scroll box is not correct. It is too small or too big.
  • If the scroll box is at the bottom of the scroll bar when you press the "Up" scroll arrow, you need to press the button more times than expected to reach the top, because some presses have no effect.
  • Assume that at least one of the list items is longer than the visible screen size that triggered the horizontal scroll bar to be displayed. You move the vertical scroll box to its top position. When you click on the area below the scroll box, it will move approximately 70 percent of the way down. When you click below the scroll box again, nothing happens. Therefore, you cannot move the scroll box to the bottom unless you press the "Down" scroll arrow.

More Information

Software update information


Download information

The Windows Embedded Compact 7 Monthly Update (September 2013) is now available from Microsoft. To download this Windows Embedded Compact 7 Monthly Update, go to the following Microsoft Download Center website:


The kind of processor that each file applies to is visible in the name of each file in the "File information" section.

Prerequisites

This update is supported only if all previously issued updates for this product have also been installed.

Restart requirement

After you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:
  • On the Build menu, click Clean Solution, and then click Build Solution.
  • On the Build menu, click Rebuild Solution.
You do not have to restart the computer after you apply this software update.

Update replacement information

This update does not replace any other updates.
File information

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References

For more information about software update terminology, click the following article number to view the article in the Microsoft Knowledge Base:
824684 Description of the standard terminology that is used to describe Microsoft software updates

Properties

Article ID: 2881753 - Last Review: Oct 8, 2013 - Revision: 1

Feedback