"Cannot save the object '\FolderName'" error message when you try to replicate Exchange Server 2010 public folders

Applies to: Exchange Server 2010 Service Pack 3Exchange Server 2010 EnterpriseExchange Server 2010 Standard

Symptoms


Assume that you have a Microsoft Exchange Server environment that contains many Exchange Server 2010 Mailbox servers. You try to add a replica of a public folder to every single public folder database in the environment at the same time. When the two hundred fifty-eighth Mailbox server is added to the public folder replica list, the replica list becomes empty. Additionally, you receive the following error message:
The following error(s) occurred while saving changes:
Set-PublicFolder
Failed
Error:
Cannot save the object '\FolderName'. Make sure that you specified the correct Identity and that you have the necessary permissions to save it.
MapiExceptionNotEnoughMemory: Unable to set properties on object. (hr=0x8007000e, ec=1009)
Diagnostic context:
Lid: 16696
Lid: 14720 StoreEc: 0x3F1
Lid: 25761
Lid: 1940 StoreEc: 0x3F1
Lid: 25297
Lid: 21201 StoreEc: 0x3F1

Note If you add the two hundred fifty-eighth server individually to the replica list, this error does not occur.

Cause


This issue occurs because the replica list is cleared out when it reaches the two hundred fifty-seventh server. 

Resolution


To resolve this issue, install the following update rollup:
2917508 Description of Update Rollup 5 for Exchange Server 2010 Service Pack 3

Status


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

More Information


For more information about how to configure public folder replication, go to the following Microsoft website: