Error message when you use the Remote Access console to remove VPN IP address ranges in Windows Server 2012 and Windows Server 2012 R2

S’applique à : Windows Server 2012 R2 DatacenterWindows Server 2012 R2 StandardWindows Server 2012 Datacenter

Symptoms


When you try to remove virtual private network (VPN) IP address ranges by using the Remote Access console, the operation may fail, and you receive the following error message:
Removing VPN IP Address Range
Finishing operations after applying configuration
A parameter cannot be found that matches parameter name 'IPv4Address'.
Attempting to roll back the configuration.

This issue occurs when you try to remove two or more VPN IP address ranges in the same operation.

Workaround


To work around this issue, do one of the following:
  • Remove only a single VPN address range, and then apply the changes in the Remote Access console. Repeat this procedure until all the desired address ranges are removed.
  • Use Windows PowerShell to remove individual address ranges one at a time by using the following cmdlet syntax:
    Remove-VpnIPAddressRange -IPAddress  <string>  -ComputerName  <string> 
    For example, run the following cmdlet:
    Remove-VpnIPAddressRange -IPAddress 192.168.1.1 -ComputerName DA.Contoso.com 

More Information


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.