A command-line action that has a linked package doesn't start in System Center 2012 Configuration Manager

Applies to: Microsoft System Center 2012 Configuration Manager

Symptoms


A task sequence (TS) doesn't start as expected in System Center 2012 Configuration Manager. This issue occurs if the Run Command Line Action sequence step has a link to a package, and the deployment for the task sequence has the Download all contents locally before starting task sequence configuration applied to it.

This problem occurs only if multiple task sequences include the same package, and the package has a larger source size.

Resolution


Hotfix information

A supported hotfix is available from Microsoft. However, this hotfix is intended to correct only the problem that is described in this article. Apply this hotfix only to systems that are experiencing the problem described in this article. This hotfix might receive additional testing. Therefore, if you are not severely affected by this problem, we recommend that you wait for the next software update that contains this hotfix.

If the hotfix is available for download, there is a "Hotfix download available" section at the top of this Knowledge Base article. If this section does not appear, contact Microsoft Customer Service and Support to obtain the hotfix.

Note If additional issues occur or if any troubleshooting is required, you might have to create a separate service request. The usual support costs will apply to additional support questions and issues that do not qualify for this specific hotfix. For a complete list of Microsoft Customer Service and Support telephone numbers or to create a separate service request, visit the following Microsoft website: Note The "Hotfix download available" form displays the languages for which the hotfix is available. If you do not see your language, it is because a hotfix is not available for that language.

Prerequisites

To apply this hotfix, you must have Cumulative Update 4 for System Center 2012 Configuration Manager Service Pack 1 installed.

Restart information

You do not have to restart the computer after you apply this hotfix.

Note We recommend that you close Configuration Manager Administration Console before you install this hotfix package.

Hotfix replacement information

This hotfix does not replace any previously released hotfix.

Status


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References


Learn about the terminology that Microsoft uses to describe software updates.