FIX: Cannot receive the GID_END gesture message in an SWE application on a Windows Embedded Compact 7-based device

Symptoms

Assume that you run a Microsoft Silverlight for Windows Embedded (SWE) application on a Windows Embedded Compact 7-based device. When you register a gesture event handler on a control (for example the Canvas or Button control), your application code is called in the event handler for all gesture messages except the GID_END one.

More Information

Software update information


Download information

The Windows Embedded Compact 7 Monthly Update (May 2014) is now available from Microsoft. To download this Windows Embedded Compact 7 monthly update, go to the following Microsoft Download Center website:


The kind of processor that each file applies to is visible in the name of each file in the "File information" section.

Prerequisites

This update is supported only if all previously issued updates for this product have also been installed.

Restart requirement

After you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:
  • On the Build menu, click Clean Solution, and then click Build Solution.
  • On the Build menu, click Rebuild Solution.
You do not have to restart the computer after you apply this software update.

Update replacement information

This update does not replace any other updates.
File information

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References

For more information about software update terminology, click the following article number to view the article in the Microsoft Knowledge Base:
824684 Description of the standard terminology that is used to describe Microsoft software updates

Properties

Article ID: 2965743 - Last Review: Jun 20, 2014 - Revision: 1

Windows Embedded Compact 7

Feedback