FIX: The Cmd.exe command-line tool does not run multiple commands in Windows Embedded Compact 2013

Introduction

This article describes an issue in which the Cmd.exe command-line tool does not run multiple commands in Windows Embedded Compact 2013. An update is available to resolve this issue. Before you install this update, all previously issued updates for this product must be installed.

Symptoms

You have a batch file that should run multiple commands in Windows Embedded Compact 2013. For example, you have the following batch file:

cmd /c pword.exe 
cmd /c control.exe
cmd /c peghelp.exe

When you run the batch file as the first command of an instance of the Cmd.exe command-line tool, only the first command of the batch file is run. The other commands in the batch file are not run.

Software update information

Download information

Windows Embedded Compact 2013 Monthly Update (May 2015) is now available from Microsoft. To download this monthly update, go to Microsoft OEM Online or MyOEM.

Prerequisites

This update is supported only if all previously issued updates for this product have also been installed.

Restart requirement

After you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:
  • On the Build menu, click Clean Solution, and then click Build Solution.
  • On the Build menu, click Rebuild Solution.
You do not have to restart the computer after you apply this software update.

Update replacement information

This update does not replace any other updates.

File information

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References

Learn about the terminology that Microsoft uses to describe software updates.
Properties

Article ID: 3069568 - Last Review: Jun 16, 2015 - Revision: 1

Feedback