FIX: Slider won't move after the control is re-enabled in an SWE application on a Windows Embedded Compact 7 device

Introduction

This article describes an issue that prevents you from moving the slider after a slider control is re-enabled in a Silverlight for Windows Embedded (SWE) application in Windows Embedded Compact 7. An update is available to resolve this issue. Before you install this update, all previously issued updates for this product must be installed.

Symptoms

In a Silverlight for Windows Embedded (SWE) application on a Windows Embedded Compact 7 device, assume that you disable a slider control in the application. After you re-enable the control, you can't move the slider as expected.

Resolution

Software update information

A supported software update is now available from Microsoft as Windows Embedded Compact 7 Monthly Update (April 2016).

Note This Windows Embedded Compact 7 Monthly Update is available for download from the following Microsoft Download Center website:

Prerequisites

This update is supported only if all previously issued updates for this product have also been installed.

Restart requirement

After you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:
  • On the Build menu, click Clean Solution, and then click Build Solution.
  • On the Build menu, click Rebuild Solution.
You do not have to restart the computer after you apply this software update.

Update replacement information

This update does not replace any other updates.

File information

References

Learn about the terminology that Microsoft uses to describe software updates.
Properties

Article ID: 3149512 - Last Review: May 18, 2016 - Revision: 1

Feedback