- When you restart your computer, you may be prompted to use the Last Known Good configuration. When you do so, your computer may stop responding (hang) during the restart, and each time you restart thereafter.
- You may be prompted to run ScanDisk. When you do so, your computer may stop responding (hang). If you do not run ScanDisk, your computer may start correctly. However you are prompted to run ScanDisk every time you start your computer, and if you do so, your computer may stop responding (hang).
- When you restart your computer, your computer may stop responding (hang).
- If you try to restart your computer in Safe mode, your computer may stop responding (hang) when Windows XP tries to load the Agp440.sys service.
Important You must know the administrator password to complete the following procedure. If you do not know the administrator password, contact your system administrator. After you complete this procedure, any video adapter driver you have installed will be disabled, and Windows XP will use default VGA drivers.
- Insert your Windows XP CD-ROM into the computer CD-ROM drive or DVD-ROM drive, and then restart your computer from the CD-ROM.
Note Some computers may require that you modify the basic input/output system (BIOS) settings before you can start the computer from a CD-ROM. For information about how to modify the BIOS, see your computer documentation.
- At the Welcome to Setup screen, press R to start the Recovery Console.
- Press the number key that corresponds to the installation that you want to repair, and then press ENTER.
- Type the password for the administrator account of that installation, and then press ENTER. You receive a drive:WINDOWS> prompt, where drive is the drive on which Windows XP is installed.
- Type listsvc, and then press ENTER.
- Make sure that the Agp440 service is listed, and that the startup type is set to "Boot".
- Press ESC.
- Type disable agp440, and then press ENTER.
- You receive a message that the registry setting for this service was found, and that its current startup state is "service_disabled".
- Type exit, and then press ENTER.
- If you are prompted to start in Safe mode or Normal mode, start in Normal mode.
- Log on to your computer.