- How to use the Diskpart.exe command prompt utility to extend a data volume into unallocated space in Windows Server 2003, in Windows XP, and in Microsoft Windows 2000.
- How to extend the boot partition in Windows Server 2008.
How to use Diskpart.exe to extend a data volume in Windows Server 2003, in Windows XP, and in Windows 2000You can use the Diskpart.exe utility to manage disks, partitions, and volumes from a command-line interface. You can use Diskpart.exe on both Basic disks and Dynamic disks. If an NTFS volume resides on a hardware RAID 5 container that can add space to the container, you can extend the NTFS Volume with Diskpart.exe while the disk remains a Basic disk.
Use the extend command to incorporate unallocated space into an existing volume while preserving the data.
The following are the requirements for the
- The volume must be formatted with the NTFS file system.
- For Basic volumes, the unallocated space for the extension must be the next contiguous space on the same disk.
- For Dynamic Volumes, the unallocated space can be any empty area on any Dynamic disk on the system.
- Only the extension of data volumes is supported. System or boot volumes may be blocked from being extended, and you may receive the following error: Diskpart failed to extend the volume. Please make sure the volume is valid for extending
- You cannot extend the partition if the system page file is located on the partition. Move the page file to a partition that you do not want to extend.
- At a command prompt, type
- Type list volume to display the existing volumes on the computer.
- Type Select volume volume number where volume numberis number of the volume that you want to extend.
- Type extend [size=n] [disk=n] [noerr]. The following describes the parameters: size=n
The space, in megabytes (MB), to add to the current partition. If you do not specify a size, the disk is extended to use all the next contiguous unallocated space.
The dynamic disk on which to extend the volume. Space equal to size=n is allocated on the disk. If no disk is specified, the volume is extended on the current disk.
For scripting only. When an error is thrown, this parameter specifies that Diskpart continue to process commands as if the error did not occur. Without the noerr parameter, an error causes Diskpart to exit with an error code.
- Type exit to exit Diskpart.exe.
Note In Windows XP and in Windows 2000, you cannot use Diskpart.exe to extend a simple volume on a Dynamic disk that was originally created on a Basic disk. You can extend only simple volumes that were created after the disk was upgraded to Dynamic disk. If you try to extend a simple volume on a Dynamic disk that was originally created on a Basic disk, you receive the following error message. This restriction was removed in Windows Server 2003.
Please make sure the volume is valid for extending
To download the Diskpart.exe commandprompt utility for Windows 2000, visit the following Microsoft Web site:
Note We recommend that you contact your system vendor for updated BIOS, firmware, drivers, and agents before you convert to Dynamic disks.
How to extend the boot partition in Windows Server 2008To extend the boot partition in Windows Server 2008, follow these steps:
- Click Start, and then click Server Manager.
- In the navigation pane, expand Storage, and then click Disk Management.
- In the details pane, right-click the volume that you want, and then click Extend Volume.
- Follow the instructions in the Extend Volume Wizard to extend the boot partition.