FIX: A Windows Embedded Compact 7 device cannot reconnect to an SMB share after sending a TCP RST command

Koskee seuraavia: Windows Embedded Compact 7

Introduction


This article describes a problem in which a Windows Embedded Compact 7-based device cannot reconnect to a server message block (SMB) share after you send a TCP reset (RST) command. An update is available to resolve this problem. Before you install this update, all previously issued updates for this product must be installed.

Symptoms


After you send a TCP RST command from a Windows Embedded Compact 7-based device, the device cannot reconnect to an SMB share.

Cause


This problem occurs because of the post-wait time-out value when the NetBIOS session is closed. When you reconnect the network cable at the SMB server end, and then you try to reconnect to the SMB share, the device tries to communicate directly with the SMB Service. Because the logical connection (NetBIOS session) isn't established, the communication fails.

Software update information


A supported software update is now available from Microsoft as Windows Embedded Compact 7 Monthly Update (September 2017).

Note This Windows Embedded Compact 7 Monthly Update is available for download from the following Microsoft Download Center website:

Windows Embedded Compact 7 Updates

Prerequisites

This update is supported only if all previously issued updates for this product have also been installed.

Restart requirement

After you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:

  • On the Build menu, click Clean Solution, and then click Build Solution.
  • On the Build menu, click Rebuild Solution.

You don't have to restart the computer after you apply this software update.

Update replacement information

This update does not replace any other updates.

File information

References


Learn about the terminology that Microsoft uses to describe software updates.