Article ID: 125480 - View products that this article applies to.
This article was previously published under Q125480
This article has been archived. It is offered "as is" and will no longer be updated.
One of the following symptoms may occur:
Windows Setup was unable to update your system files
This may be caused by virus detection that is built-in to your machine, or by virus detection software running on your system.
To disable built-in virus detection you will need to run the configuration program for the CMOS that came with your machine, or contact your machine manufacturer.
To disable virus-detection software that you have running on your system, you may need to remove the lines that start the program from your AUTOEXEC.BAT or CONFIG.SYS files.
After you have disabled the virus detection software, re-start your machine and re-run Windows Setup. Once you have successfully completed setup, it is okay to re-enable the virus detection software.
NOTE: The following error message may also be encountered:
Warning: disk boot sector is to be modified, press Y to accept, and any key to abort.
Some computers include a feature that prevents applications from writing to the boot sector. Such features are normally in the form of anti-virus protection set in your computer's CMOS settings. If anti-virus protection is enabled, Windows cannot complete its installation, or it does not load properly.
Disable the anti-virus feature in your computer's CMOS settings, and then reinstall Windows. Once you have successfully installed Windows, re-enable the anti-virus feature.
For information about accessing your computer's CMOS settings, please consult your owner's manual or your computer manufacturer.
NOTE: In order to disable Compaq's SafeStart Manager in the CMOS settings, you must upgrade the BIOS to at least version 2.26b.
The following computers have been found to display this problem: