You are currently offline, waiting for your internet to reconnect

Works 95: How to Remove Header/Footer from Word Processing File

This article was previously published under Q137079
Retired KB Content Disclaimer
This article was written about products for which Microsoft no longer offers support. Therefore, this article is offered "as is" and will no longer be updated.
SUMMARY
When you create a new Word Processor document in Works versions 4.0, 4.0a, 4.5, or 4.5a for Windows 95, Works creates the document with a header and footer that you are unable to remove. Works sets the header and footer size to either the margin size located in Page Setup, or to the point size of the font, whichever is larger.
MORE INFORMATION
To reduce the header to the smallest size allowable, do the following:

  1. Click the cursor in the header area.
  2. Change the font size to 4. This is the minimum font size allowed by Works.

    NOTE: In most cases the number 4 is not listed in the Font Size list, so you must type in the number 4.
  3. On the File menu, click Page Setup.
  4. Click the Margins tab.
  5. Set the top margin to zero and click OK.
Works takes into account the nonprintable region of a printer. Thisinformation is supplied to Works by the printer driver, and may vary foreach printer. In the From Edge section of the Page Setup dialog box, the value for the Header margin and Footer margin are the actual nonprintable regions of the printer driver.
4.00 4.00a 4.50 4.50a w_works
Properties

Article ID: 137079 - Last Review: 11/15/2004 23:43:49 - Revision: 4.0

  • Microsoft Works 4.5 Standard Edition
  • Microsoft Works 4.5a
  • Microsoft Works 4.0 Standard Edition
  • Microsoft Works 4.0a
  • kbinfo KB137079
Feedback