Creating Alternate Boot Selections on AXP Machines

This article was previously published under Q139333
This article has been archived. It is offered "as is" and will no longer be updated.
If the primary drive in a mirror set fails on a DEC Alpha computer, it isnecessary to have alternate boot paths created in the system firmware.There are two methods which can be used to boot the machine to theshadow drive in the mirror set.

NOTE: The system partition contains OSLOADER.EXE, HAL.DLL and the *.PALfiles required to load the operating system. The boot partition is thepartition that has the Windows NT system files.

Method 1

This method requires that the system partition be the same as the bootpartition, or that both the system and boot partitions be mirrored:
  1. Boot the system. The first menu will be the System Boot Menu.
    1. Select Supplementary menu.
    2. Select Setup the system.
    3. Select Manage boot selections.
  2. From the Manage boot selections menu, select Add a boot selection.
  3. At the following prompts enter the correct information for your system.

    NOTE: When a specific path is requested may vary from one computer to another.

    "Select a system partition for this boot selection"
    Choose: New system partition

    "Enter location of the system partition for this boot selection"
    Choose: SCSI Hard Disk

    "Enter the osloader directory and name"
    Type: \os\winnt351\osloader.exe

    "Is the operating system in the same partition as the osloader:"
    Choose: No

    NOTE: This will also vary from one computer to another. The example here reflects the most common RISC configuration. The system and boot partitions are separate

    "Enter the location of the os partition"
    "Select media"
    Choose: SCSI Hard Disk

    "Enter SCSI bus number"
    Type in the appropriate bus number.

    "Enter SCSI ID"
    Type in the appropriate SCSI ID

    "Enter partition"
    Type in the appropriate partition number.

    "Enter the operating system roor directory"
    Type in the path. For example: \winnt35

    "Enter the name for this boot selection"
    Type in a name. For example: Boot Shadow Drive

    "Do you want to initialize the debugger at boot time:"
    Choose Yes or No
After you enter the data the Setup menu appears again. Choose"Supplementary menu, and save changes" to exit the Setup menu. The changeswill be saved in NVRAM. The new boot selection will become the default. The"Manage boot selections" menu has a option to rearrange boot selections ifyou do not want the new selection to be the default.

Method 2

This method is useful if you want to create a Fault Tolerant Floppy(FTF). This will allow you to keep the system partition files on a floppydisk.
  1. Format a floppy disk of the correct size.
  2. Create a directory on the floppy that is the same as the osloader directory on the system partition. For example:

  3. Copy the following files into the osloader directory:

    All files with the extension PAL.

    NOTE: The .PAL files may have the hidden and system attribute set. These files will always be in the osloader directory on the system partition.
  4. Follow the same steps as outlined in Method 1 with the following exception: After selecting New system partition, choose Floppy Disk as the target media. Then enter the floppy disk number when prompted. The rest of the steps are identical to those outlined in Method 1.

Article ID: 139333 - Last Review: 09/27/2013 21:56:21 - Revision: 3.1

Microsoft Windows NT Workstation 3.51, Microsoft Windows NT Server 3.51

  • kbnosurvey kbarchive kbhowto KB139333