This article was previously published under Q142899
This article contains information about using Windows in a configurationthat has not been tested and is not supported by Microsoft. If the stepsdescribed in this article do not function properly, use a supportedconfiguration.
This article describes how to configure HyperTerminal to answer anincoming phone call.
To set up HyperTerminal to answer an incoming call, follow these steps:
Click the Start button, point to Programs, point to Accessories (or Communications), and then click HyperTerminal.
Double-click the Hypertrm.exe icon. You may want to name the connection "Answer Mode."
Enter the information for the connection, and then click OK.
Because you will use this connection for answering, the phone number you enter is not important. However, you must enter a phone number.
Click Cancel to bypass the connect process.
On the File menu, click Properties.
On the Settings tab, click ASCII Setup.
You may want to set one or more of the following properties to allow characters to be displayed properly in the Terminal window:
Send line ends with line feed
Echo typed characters locally
Append line feeds to incoming lines
Wrap lines that exceed terminal width
Click OK. Click OK again to return to HyperTerminal.
Wait for the incoming call. When you see the command "ring" or you hear the phone ring, type the answer command for your modem. On many modems, the answer command is "ATA."
NOTE: If your modem supports automatic answering mode, type the following command to cause the modem to answer incoming calls automatically: