Windows NT May Hang or Show "Stop 0x1E" Error with Iomega Drive

This article was previously published under Q166393
This article has been archived. It is offered "as is" and will no longer be updated.
SYMPTOMS
When you are using the Iomega Parallel Port Zip Drive drivers version1.41, Windows NT may hang or display a "STOP 0x1E" error message atstartup.
CAUSE
The drive is not connected to the parallel port.
RESOLUTION
To correct this behavior, use one of the following methods.

Method 1

  1. In Control Panel, double-click Devices.
  2. In the list of devices, click PPA3NT.
  3. Click Startup, and then set the device to Manual. Manually start the PPA3NT device by repeating steps 1-2 and clicking Start to load the driver when the drive is connected.

Method 2

  1. In Control Panel, double-click Devices.
  2. In the list of devices, click PPA3NT.
  3. Click Startup and then set the device to Disabled. When the drive is connected, set the device to Boot.

Method 3

Contact the manufacturer for a possible updated driver.
MORE INFORMATION
The third-party product discussed in this article is manufactured by avendor independent of Microsoft; we make no warranty, implied orotherwise, regarding this product's performance or reliability.
Properties

Article ID: 166393 - Last Review: 10/06/2013 23:28:38 - Revision: 1.1

  • Microsoft Windows NT Server 4.0 Standard Edition
  • Microsoft Windows NT Workstation 4.0 Developer Edition
  • kbnosurvey kbarchive kbenv kberrmsg kbhardware KB166393
Feedback