Article ID: 186150 - View products that this article applies to.
This article was previously published under Q186150
This article has been archived. It is offered "as is" and will no longer be updated.
When using NetBEUI on an Arcnet network, the NetBEUI protocol may stop responding (hang) after a period of high network activity occurs. The computer has to be restarted to recover from this condition.
NetBEUI keeps a cache of NDIS packets. This means that NetBEUI can send the same packet multiple times. The problem is that NDIS is not clearing out the timeout status bit in the packet descriptor. NDIS maintains a counter that runs about every two seconds. The first pass of the timer, it will set this timeout status on the first packet in the packet queue. The second time the timer runs, it checks to see if this bit is set. If it is, NDIS will reset the adapter. Because NDIS is not resetting the timeout status, a reset of the adapter could occur. There is also a problem with reset recovery that would cause the protocol to stop responding.
To resolve this problem, obtain the latest service pack for Windows NT 4.0 or Windows NT Server 4.0, Terminal Server Edition. For additional information, click the following article number to view the article in the Microsoft Knowledge Base:
(https://support.microsoft.com/kb/152734/EN-US/ )How to Obtain the Latest Windows NT 4.0 Service Pack
Microsoft has confirmed that this is a problem in Windows NT 4.0 and Windows NT Server 4.0, Terminal Server Edition. This problem was first corrected in Windows NT 4.0 Service Pack 4.0 and Windows NT Server 4.0, Terminal Server Edition Service Pack 4.
Article ID: 186150 - Last Review: October 8, 2013 - Revision: 2.2