ACC: “Setup is configuring Access” message is received each time Access is launched
The following message appears each time you open Access on a PC that has or has had a previous version of Access installed.
"Setup is configuring Access."
This problem occurs if you were a non-admin user the first time you ran Access and you are now running a newer version of Access. If you were a non-admin user the first time you ran Access, the registry key that specifies the current version of Access is created in HKCU\Software\Classes. Once an admin user launches Access, the current version key is created under HKLM\Software\Classes. When you install a newer version of Access, only the HKLM\Software\Classes key is updated. The HKCU\Software\Classes key is still checked when launching Access, causing Access to attempt a repair.
Verify that the following registry key exists:
If the key above exists, then delete the following registry key:
To work around this issue, you can remove or rename the Access.Application\CurVer key from HKCU\Software\Classes.
Αναγνωριστικό άρθρου: 2184729 - Τελευταία αναθεώρηση: 12/28/2012 19:04:00 - Αναθεώρηση: 3.0