You are currently offline, waiting for your internet to reconnect

Windows 2000 Hangs at "Setup Is Starting Windows 2000" Message

This article was previously published under Q234772
SUMMARY
This article lists troubleshooting steps to try if Windows 2000 Text-mode Setup stops responding (hangs) while displaying the "Setup is starting Windows 2000" message.
MORE INFORMATION
The following items can cause Setup to hang while displaying the "Setup is starting Windows 2000" message:
  1. An incorrect mass-storage device (such as a SCSI or IDE controller) driver is being loaded, or the driver was not written for Windows 2000 and is not compatible. Contact the device's manufacturer or download the latest driver for the mass-storage device. For additional information, click the article number below to view the article in the Microsoft Knowledge Base:
    216406 Specifying Third-Party Disk Controller Driver During Setup
  2. There is a device connected to your mass-storage device that is preventing Windows 2000 from being installed. Remove any devices (such as scanners, tape drives, removable drives, and so on) from the mass-storage device controller. If the computer is IDE-based, verify that you have the master and slave designations set properly. If the mass-storage controller is SCSI-based, verify that the termination and bus speed is set properly.
  3. The computer does not have the latest BIOS revision. Contact the computer's manufacturer or check the manufacturer's Web site. Many manufacturers have updated their BIOS revisions to properly support Advanced Configuration and Power Interface (ACPI).
  4. An ACPI Hardware Abstraction Layer (HAL) is being used during Setup. Force the use of a non-ACPI HAL during Setup. For additional information about how to do this, click the article number below to view the article in the Microsoft Knowledge Base:
    216251 How to Specify a Specific or Third-Party HAL During Setup
For additional information, click the article numbers below to view the articles in the Microsoft Knowledge Base:
224826 Troubleshooting Text-Mode Setup Problems on ACPI Computers
220845 Adding Third-Party or Updated Driver During Windows 2000 Setup
Properties

Article ID: 234772 - Last Review: 02/26/2007 23:10:41 - Revision: 3.2

  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional Edition
  • kbhardware kbinfo kbsetup kbtshoot KB234772
Feedback