Article ID: 239924 - View products that this article applies to.
This article was previously published under Q239924
On a Windows-based computer that uses TCP/IP, you can use the Media Sensing feature to detect whether the network media are in a link state. Ethernet network adapters and hubs typically have a "link" light that indicates the connection status. This status is the same condition that Windows interprets as a link state. Whenever Windows detects a "down" state, it removes the bound protocols from that adapter until it is detected as "up" again. Sometimes, you may not want the network adapter to detect this state. You can set this configuration by modifying the registry.
Note 10B2 coaxial (RG-58) Ethernet cable is not a connection-based medium. Therefore, Windows does not try to detect a link state when this kind of cabling is used.
To have us prevent the network adapter from detecting a link state for you, go to the "Fix it for me" section. If you prefer to fix this problem yourself, go to the "Let me fix it myself" section.
Fix it for me
To fix this problem automatically, click the Fix it button or link. Click Run in the File Download dialog box, and follow the steps in the Fix it wizard.
Fix this problem
Microsoft Fix it 50492
Then, go to the "Did this fix the problem?" section.
Let me fix it myselfImportant This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(https://support.microsoft.com/kb/322756/ )How to back up and restore the registry in Windows
To prevent the network adapter from detecting a link state, follow these steps.
Note The NetBEUI protocol and the IPX protocol do not support Media Sensing.
Key: HKEY_LOCAL_MACHINE\Cluster\ParametersBy default, the DisableClusSvcMediaSense entry is set to 0. When this entry is set to 0, Media Sensing is disabled. If you set the DisableClusSvcMediaSense entry to 1, you can use the DisableDHCPMediaSense entry to enable Media Sensing. This behavior matches the behavior of a Microsoft Windows 2000 Server cluster environment.
Data type: REG_DWORD (Boolean)
Default value: 0
Did this fix the problem?
Article ID: 239924 - Last Review: September 1, 2010 - Revision: 12.0