You are currently offline, waiting for your internet to reconnect

"Use Default Gateway on Remote Network" Check Box Is Unavailable

This article was previously published under Q254762
SYMPTOMS
When you view the advanced TCP/IP properties of a demand-dial interface that is listed in the Routing Interfaces container in the Routing and Remote Access snap-in, the Use default gateway on remote network check box may be unavailable.
CAUSE
This option is available only when you are creating a standard dial-up networking connection in the Network and Dial-up Connections tool in Control Panel.

For a demand-dial interface, create instead a default route in the Static Routes container in the Routing and Remote Access snap-in that uses the appropriate demand-dial interface.
RESOLUTION
After you create the demand-dial interface in the Routing Interfaces container, follow these steps in the Routing and Remote Access snap-in:
  1. Open the IP Routing container, right-click Static Routes, and then click New Static Route.
  2. In the Interface box, click the appropriate demand-dial interface.
  3. In the Destination box, type 0.0.0.0.
  4. In the Network Mask box, type 0.0.0.0.
  5. The Gateway box is unavailable because it is unnecessary with a dial-up connection. Change the Metric box if necessary (this is typically not necessary), and then click OK.
gray grey grayed greyed disabled out
Properties

Article ID: 254762 - Last Review: 02/28/2007 01:05:09 - Revision: 3.2

  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • kbenv kbnetwork kbprb KB254762
Feedback