You are currently offline, waiting for your internet to reconnect

Changes made to Video Hardware Acceleration settings in a System Center 2012 Configuration Manager Remote Control session are reverted when the session ends

SYMPTOMS
Consider the following scenario:
  • You have a Microsoft System Center 2012 Configuration Manager site server and a Microsoft System Center 2012 Configuration Manager Client.
  • The Video Hardware Acceleration setting on the Configuration Manager Client is set to Full.
  • A Remote Control session is established to the Configuration Manager Client.
  • The Video Hardware Acceleration setting is changed during the Remote Control session. For example, you change the setting from Full to None.
  • You exit the Remote Control session as usual.

In this scenario, the Video Hardware Acceleration setting is set back to Full on the client after the Remote Control session is exited. You would expect the setting to remain the same as you set it during the remote control session.
CAUSE
This occurs because of the design of Remote Control in System Center 2012 Configuration Manager. When a Remote Control session is established, the current Hardware Acceleration setting on the client is recorded, and Hardware Acceleration is disabled for performance reasons. After the Remote Control session, the original Hardware Acceleration setting is restored. This causes any change made to Hardware Acceleration during the session to be overwritten with the original setting.
WORKAROUND
To work around this issue, a member of the local Administrator group on the client must adjust the settings outside a System Center Configuration Manager Remote Control session.
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
Properties

Article ID: 2680765 - Last Review: 07/09/2012 21:02:00 - Revision: 2.0

Microsoft System Center 2012 Configuration Manager

  • kbtshoot kbprb kbexpertiseinter kbsurveynew KB2680765
Feedback
c=""> var varAutoFirePV = 1; var varClickTracking = 1; var varCustomerTracking = 1; var Route = "76500"; var Ctrl = ""; document.write("