Article ID: 286052 - View products that this article applies to.
This article was previously published under Q286052
This article discusses the state codes that are displayed in the Cluster.log file.
NOTE: These state codes had been originally documented in the Resource Kit for Microsoft Windows 2000 Server in the Cluster Log Basics section.
When Microsoft Windows 2000 is installed, it enables the Cluster Logging feature, by default. If you want more information about this topic, refer to the following article:
234767In Microsoft Windows NT 4.0, the Cluster Logging feature has to be manually enabled. If you want to enable this feature in Windows NT 4.0, refer to the following article:
(https://support.microsoft.com/kb/234767/EN-US/ )Microsoft Cluster Server Logging Enhancements in Windows 2000
(https://support.microsoft.com/kb/168801/EN-US/ )How to Enable Cluster Logging in Microsoft Cluster Server
You can obtain error code or status code information, at a command prompt, by typing net helpmsg "error code".
In the cluster log you may receive the following error message:
With an "error 5" you can use the net helpmsg 5 command which causes the output of an "Access is denied" message. If you correlate "state 1" to the following list, you can observe that "state 1" equates to "ClusterNodeDown". You could then use this information from the cluster log and decide if there is a permissions problem with the Cluster service.
388.4e8::1999/06/09-20:20:57.281 [NM] Received advice that node 2 has failed with error 5 state 1.
Different components of the Cluster service create different state codes. The core components and their state codes are in the following lists:
State Codes for Cluster Groups
State Codes for Cluster Nodes
State Codes for Cluster Resources
State Codes for Networks
State Codes for Network Interfaces
Article ID: 286052 - Last Review: October 11, 2007 - Revision: 2.7