Visio2002: Error Message: "Error 1925. You Do Not Have Sufficient Privileges" Performing Setup with the /J Switch on NT 4.0

This article was previously published under Q293956
This article has been archived. It is offered "as is" and will no longer be updated.
SYMPTOMS
When you install Microsoft Visio 2002 using the /j command-line switch, you receive the following error message:
Error 1925. You do not have sufficient privileges to complete this installation for all users of the machine. Log on as administrator and then retry this installation.
NOTE: You receive this message even though you are logged on as administrator.
CAUSE
This issue may occur if you are installing Visio 2002 on a computer using the Microsoft Windows NT 4.0 operating system.
RESOLUTION
To work around this issue, install Visio without using the /j switch on the computer that is using Windows NT 4.0.
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
MORE INFORMATION
For additional information about Setup command-line switches, click the article number below to view the article in the Microsoft Knowledge Base:
282119 Visio2002: Setup Command-Line Switches for Visio 2002
prb
Properties

Article ID: 293956 - Last Review: 02/28/2014 04:26:55 - Revision: 4.2

Microsoft Visio 2002 Standard Edition, Microsoft Visio 2002 Professional Edition, Microsoft Windows NT Workstation 4.0 Developer Edition, Microsoft Windows NT Workstation 4.0 Developer Edition, Microsoft Windows NT 4.0 Service Pack 6, Microsoft Windows NT 4.0 Service Pack 6a

  • kbnosurvey kbarchive kbprb KB293956
Feedback