Article ID: 298743 - View products that this article applies to.
This article was previously published under Q298743
BUG #: 353349 (SHILOH_BUGS)
BUG #: 353719 (SHILOH_BUGS)
When you set up log shipping through the Database Maintenance Wizard, and the wizard fails to complete because of an error, not all of the wizard's changes are rolled back.
This may cause the following error message to occur after you fix the original problem, and then re-run the wizard:
Error 14261: The specified primary_server_name.primary_database_name ('N') already exists.
Error 14426: A log shipping monitor is already defined (...)
There are left over jobs on the log shipping monitor server and on the primary server:
After you run the Maintenance Wizard and it fails to create the Log Shipping setup, you must manually clean up the tables before you run the wizard again.
Depending on where the failure is, you must run some of the stored procedures to delete the entry.
You may have to run the following stored procedures to clean up log shipping entries and allow the wizard to be re-run:
For more information, visit the following Microsoft Web sites:
Microsoft SQL Server 2000 Resource Kit
(http://www.microsoft.com/mspress/books/toc/4939.aspx); Chapter 13
SQL Server 2000 Books Online
Article ID: 298743 - Last Review: October 24, 2012 - Revision: 3.0